Stop Thermoplastic Marking

Provide drivers with a clear instruction to halt using this preformed thermoplastic “STOP” marking. The prominent lettering and highly visible finish draw attention to points where vehicles must come to a standstill, helping improve awareness and maintain controlled traffic movement throughout your premises.

Key features

• Clearly indicates where drivers are required to stop

• Helps manage vehicle movement at busy or restricted points

• Supports safer access, junction and traffic-control procedures

• Strong, easy-to-read “STOP” lettering

• Highly visible finish for immediate recognition

• Robust construction designed for lasting outdoor performance

• Professional and hard-wearing alternative to painted markings

• Pre-cut to provide clean alignment and accurate installation

• Suitable for tarmac, asphalt and properly prepared concrete

• Supplied with anti-slip glass beads and installation guidance

• Ideal for car parks, warehouses, loading areas, private roads, industrial sites and commercial premises

  
  

Installation

Prepare the area by ensuring it is clean, dry and clear of dust or loose material. Lay out the pre-cut lettering in the desired position, then heat each section evenly with a suitable propane gas torch or lance until it has bonded firmly to the surface.

A suitable primer is necessary when fitting the marking to concrete, porous asphalt or worn tarmac. Please contact us for advice before installation on block paving, coated flooring or any other specialist surface.

Please note: Created for use on private property and in off-highway settings. Relevant authorisation is required before installation on a public highway.